Silicone rubber sealing the basic parameters: 
 This product has passed the SGS test, an environment-friendly products. Order code: G906 
 Color: black / white (color according to customer requirements) 
 Viscosity: Paste 
 Tensile strength (MPa): 
 Elongation (%): 250 
 Hardness (Shore A): 60 
 Shear strength (mPa): 
 Temperature: -60 ~ 250 ° C 
 Resistance to pressure: 12MPa 
 Fill the gap: 6mm 
 Packing: 300ml 
 Details: 
 The glue is a single component, neutral, can be cured at room temperature silicone sealant. It is non-corrosive material to be sealed, not to release irritating gases, can replace the traditional solid gasket, such as rubber, asbestos mat, cork pad and paper pad, also can be used for filling and sealing machine parts. 
 The main technical indicators and performance have reached the level of foreign imports of similar products. Proved by the many manufacturers use, it has excellent high temperature performance, good adhesion, non-corrosive, non-solvent (an environmentally friendly product), and has excellent electrical insulation and anti-arc properties, good resistance to aging and pH . 
 Use: 
 The plastic encapsulation for mechanical and electrical products, sealing, but also for cars, motorcycle engines, gear boxes, front and rear axles and various other mechanical and electrical equipment, flange, fittings, cover, combined with metal and rubber surfaces sealing adhesive. 

 Application Guide: 
 Surface cleaning: wipe with a cotton leak-proof parts of water, dust, oil and so on. Such as oil more widely available research 755 cleaning detergent or acetone. 
 Glue: The glue evenly coated on the surface was sealed with two (free blade as a coating of aids), uniform layer should be connected, no bubbles, no shortage of plastic. The amount of time should not be too much glue, so as to avoid wastage. 
 Connections are tight: glue coating to be violent in the air after about 10 minutes, and then combining the two is fit to face, connections are tight, as can be at room temperature for several hours or a day later use, seal better. Sealing of the beak open, load the glue gun. After use, tubes should be made part of extraoral residual glue, then cover tightly, remove the next time you use the plastic tube can continue to use extraoral. 
 Note: 
 1, the product does not contain solvents, do not pollute the environment, non-flammable, are environmentally friendly products. 
 2, avoid prolonged direct contact with the skin, the use of the process, if accidentally splashed into the eyes, please seek medical attention. 
 3 Do not use near fire, do not let children touch, so as to avoid eating. 
 4, Storage: Keep the original sealed storage in dry, cool place, 25 ℃ to save the following 9 months. 
 5, packaging: each 300ml; carton 20. 
 Performance indicators: 
 Matrix: Silicone Rubber 
 Color: black / white (color according to customer requirements) 
 Viscosity: Paste 
 Density: ± 
 Non-volatile content: 99% 
 Surface drying time: 15 minutes 
 Full curing time: 24 hours 
 Shear strength: ≥ 
 Shaw intensity: 60 ± 5 
 Tensile strength: